![]() ![]() You should purchase or plan on purchasing a 12 volt battery for use with the system. Most of MMC's remote stations are prewired with a charge controller and power adapter for the seismograph. The remote station you purchase or rent may or may not have the solar panel connected to the solar panel bracket on the remote station. The solar module does not have a built in blocking diode and thus requires a solar charge controller to prevent overcharging the battery and discharging the battery back through the solar panel at night. UWave Monitoring Systems uses a 30 watt solar module that measures 26.25 inches x 16.25 inches x 1 inch thick. How do I setup and connect the solar panel? Timer Wiring Harness- Positive(white/red), Negative(black).Seismograph Power Adapter- Positive(red OR black w/white stripe), Negative(black).Charge Controller OUT- Positive(red), Negative(black).Charge Controller IN- Positive(yellow), Negative(black).Solar Panel- Positive(red OR white), Negative(black).UWave Monitoring Systems uses the following components and polarity color schemes in the remote monitoring station: The negative side of the battery is normally marked with a '-' and has the color black associated with it.Īlways connect positive to positive and negative to negative or you may damage some of the electrical components in the installation. The positive side of the battery is usually marked with a '+' and typically has the color red associated with it. Batteries are polarized which means they have a positive and a negative side. When preparing to setup your 12 volt battery you should follow these simple conventions. Your local ACE Hardware store may also have 12 volt Universal batteries. We recommend their Werker Deep Cycle 12 volt 35 Ah battery.ī also has a wide selection of Universal brand batteries. Sealed Lead Acid (SLA) Absorbent Glass Mat (AGM) batteries are recommended in remote solar powered installations due to their outstanding performance in demanding applications as well as being spill proof and maintenance free.įor short duration monitoring in areas with good solar insolation or sun hours/day and with low data transmission rates you may use a smaller capacity battery such as 18 Ahįor long term monitoring or monitoring in areas with poor solar insolation and or large data transmission requirements you should choose one or more 30 Ah batteries to in order to maintain data integrity.īatteries Plus has nationwide stores if you get in a jam or you can order online. When wiring batteries in parallel always use batteries of the same type, voltage and capacity in amp hours(Ah). You may chose to wire two or more batteries in parallel to increase the capacity of the batteries. The typical remote station uses either one or two 12 volt batteries to provide power to the cellular gateway (modem) and/or backup power for the seismograph or data logger. What kind of battery do I need for the remote station and how do I set it up?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |